bump V3

libs/servo/_locales/servo-jsdoc-strings.json

@@ -0,0 +1,14 @@
+{
+  "servos.Servo.maxAngle": "Gets the maximum angle for the servo",
+  "servos.Servo.minAngle": "Gets the minimum angle for the servo",
+  "servos.Servo.run": "Set the throttle on a continuous servo",
+  "servos.Servo.run|param|speed": "the throttle of the motor from -100% to 100%",
+  "servos.Servo.setAngle": "Set the servo angle",
+  "servos.Servo.setPulse": "Set the pulse width to the servo in microseconds",
+  "servos.Servo.setPulse|param|micros": "the width of the pulse in microseconds",
+  "servos.Servo.setRange": "Set the possible rotation range angles for the servo between 0 and 180",
+  "servos.Servo.setRange|param|maxAngle": "the maximum angle from 90 to 180",
+  "servos.Servo.setRange|param|minAngle": "the minimum angle from 0 to 90",
+  "servos.Servo.setStopOnNeutral": "Set a servo stop mode so it will stop when the rotation angle is in the neutral position, 90 degrees.",
+  "servos.Servo.stop": "Stop sending commands to the servo so that its rotation will stop at the current position."
+}

libs/servo/_locales/servo-strings.json

@@ -0,0 +1,14 @@
+{
+  "servos.P0|block": "servo P0",
+  "servos.P3|block": "servo P3",
+  "servos.Servo.run|block": "continuous %servo run at %speed=speedPicker \\%",
+  "servos.Servo.setAngle|block": "set %servo angle to %degrees=protractorPicker °",
+  "servos.Servo.setPulse|block": "set %servo pulse to %micros μs",
+  "servos.Servo.setRange|block": "set %servo range from %minAngle to %maxAngle",
+  "servos.Servo.setStopOnNeutral|block": "set %servo stop on neutral %enabled",
+  "servos.Servo.stop|block": "stop %servo",
+  "{id:category}Servos": "Servos",
+  "{id:group}Configuration": "Configuration",
+  "{id:group}Continuous": "Continuous",
+  "{id:group}Positional": "Positional"
+}